鋁合金噴涂前處理成膜劑

一、開槽參數 (tank set up parameters)

DBR-801：30～50g/L           

二、控制參數 (coolling parameters)

Cr6+：3～8g/L

F- : 0.2~0.4g/l

PH：1.8～2.5

溫度 (Temperature) ：20～40℃

時間 (Time) ： 1～8 min                                

三、維護和管理 (maintenance and coolling)

1.每天分析槽液濃度并依據分析結果及時調整，每處理100m2約消耗DBR-801：0.6～1.0kg。

Analysis the bath solution conceation one time a day ,according to the analysis results to adjust.

DBR-801 of consumption is 0.8～1.5kg for each 100m² treatment.

 2.每天檢測一次槽液PH值，偏高用稀酸調整；偏低用水稀釋槽液。

The PH value of the bath need to detection every wong time, when it is high, use the hydrofluoric acid to adjust, when the PH value is low, adjust with sodium hydroxide. .

 3.正常生產時如處理時間延長且補加DBR-801效果仍不理想，建議更新部分槽液。

When dipping time extended or added more DBR-801, the coating the coating surface is still not satisfactory, we suggested update some of solution of tank.

 4.不生產時加蓋槽液以防其它槽液及雜物串入污染。

Covered the tank when stop producing to prevent contamination.